Sidewall

Product Introduction

Our reinforced rubber sidewall is built with high grade rubber compound plus integrated fabric reinforced inner layers. It is made to stand heavy repeated bending, fight fatigue damage and stop corrugation fold cracks in material handling sites.

Lots of real world dynamic fatigue lab tests have been completed to verify its field performance. We supply multiple rubber grades and carry standard sizes, plus custom made dimensions for special site requirements. Even under tough, continuously changing working conditions, this conveyor sidewall rubber holds stable long term service for your belt conveyor systems.

Common application scenarios: bulk material conveying, mining, quarry, cement plant, grain processing and port material transfer. It works well to prevent material spill over along conveyor edges.

Product Details

Sidewall – Reinforced for Maximum Flexing Resistance

Premium Rubber Compound

Specially formulated rubber compound delivers exceptional flexing and fatigue resistance.

Ensures long service life under continuous bending stress.

Fabric-Reinforced Crack Prevention

Integrated fabric reinforcement effectively prevents cracks at corrugation folds.

Targets the most critical stress points where cracks typically initiate.

Standard & Custom Reinforcement Options

Models from type S120/MDSF120 and above: diagonal fabric reinforcement within corrugations as standard.

Smaller profiles: this feature available upon request.

Validated by Dynamic Fatigue Testing

Every batch goes through strict dynamic fatigue testing. Test setup simulates actual on site bending, load and cycle conditions your conveyor will meet. Only sidewalls passing full fatigue validation leave our factory, so end users get reliable performance out in the field.

Rubber Quality

Abrasion-resistant

Acid & Alkali-resistant

Flame-retardant

Anti-stick

High/Moderate Oil-resistant

Cold-resistant

Heat-resistant (100~150℃)

High Temperature-resistant (150-250℃)

Other Customized Types

FAQ

Q1: When should I choose fabric reinforced rubber sidewall instead of standard sidewall?

A: Choose fabric reinforced sidewall if your conveyor runs frequent bending, uses small pulley diameter, or works under heavy load bulk material. Reinforced types greatly lower corrugation crack risk. For height over 120 mm, diagonal fabric reinforcement is our strong suggestion. Even for lower height sidewall, you can add fabric carcass for longer service life.

Q2: Can you make custom size reinforced conveyor sidewall?

A: Yes. Apart from standard S / MDSF / HHDF series, we accept custom height, width and special rubber formula. Send over your working condition, pulley size and media information, our team will give matching proposal.

Q3: Which rubber grade fits high heat conveying sites?

A: We supply two heat resistant grades: heat resistant for 100 150℃ and high temperature resistant grade for 150 250℃. Tell us your continuous working temperature and contact media, we will recommend proper rubber compound.

Q4: Why does corrugated sidewall crack quickly in field?

A: Common causes include too small pulley diameter, over load operation, wrong rubber grade for environment, or lack of inner fabric reinforcement. Follow our minimum pulley diameter requirement and pick fabric reinforced construction for high stress application to avoid early crack failure.

Q5: What industries commonly use your reinforced rubber sidewall?

A: Our corrugated fabric reinforced sidewall is widely used in mining, quarry, cement plant, grain handling, port terminals, chemical and metallurgy industries for inclined belt conveyors.

Q6: Do you test every rubber sidewall before shipment?

A: We run dynamic fatigue test for product validation. Sampling tests are carried out for each production batch to check flex resistance and anti crack performance, simulating real conveyor operation cycles.